Watlow ANASCAN User Manual download pdf (Page 14)

6 ANASCAN User’s Guide

INSTALLATION

PLOT.DAT - plot parameters data file

Files created by ANASCAN:

XXXXXXXX.J## - group job directory data file

NEWXX.PLT - plot files which were created within the last 24 hours.

OLDXX.PLT - older plot files

PXXXXXXX.TXT or WK1 process logging files

AXXXXXXX.TXT or WK1 alarm logging files

WARNING

Make copies of disks before running the program, and store the

original ANASCAN disks in a safe place. Use the copies to oper-

ate the system.

File Locations

360k dual floppy disk system:

Watlow Anafaze recommends that you store the ANASCAN operating

program file and the INSTAL.DAT file on drive A, and all other files on

drive B. Once the program SCANINST is run, you can remove

SCANINST.EXE from drive B to allow more room for data. Do not

remove files from the master disk. This recommendation ensures that

the autoboot feature will bring up the program automatically in the

occurance of a power outage.

720k or higher floppy disk system:

Watlow Anafaze recommends that you store all files of the ANASCAN

operating program on one drive such as A. Use the B drive to store all

recording data by setting up directories as shown in the hard disk system

recommendations.

Hard disk systems:

Watlow Anafaze recommends setting up directories as follows:

ANASCAN - to contain the operating program, system data and job

files

DATALOG - to contain data logging files generated by ANASCAN

ALARMLOG - to contain alarm logging files generated by ANASCAN

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 61 62

No comments

Watlow ANASCAN User Manual Page 14