5.10 WATLOW Series 982 User’s Manual
Operation Menus, Chapter 5
System
Menu
p. 5.2
PID
Menu
p. 5.10
Program
Menu
p. 7.1
❶ Begin in the Display Loop, and
press the Mode key µ to reach the
the Operation menus [OPEr].
❷ Use the Up-arrow > key to
select a menu.
Figure 5.10 -
The PID Menus.
❸ Press the Mode key µ to step
through the prompts.
❹ Press the Up-arrow key > to
step through the prompt values.
The Down-arrow key < backs
through the values.
…
…
…
*Prompts may not
appear, depending on
controller configuration.
Reaching the PID Menus
Operation-PID
→ [`Pid] PID Menu
↑
µ
[OPEr] Operation Menus
↓
?
µ
[`Pb1] *Output 1 Proportional Band (page 5.11)
↓ ?
µ
[`rE1] *Output 1 Reset
↓ ?
µ
[`It1] *Output 1 Integral
↓ ?
µ
[`rA1] *Output 1 Rate
↓ ?
µ
[`dE1] *Output 1 Derivative
↓ ?
µ
[`CtI] *Output 1 Cycle Time
↓
?
µ
[`Pb2] *Output 2 Proportional Band (page 5.14)
↓ ?
µ
[`rE2] *Output 2 Reset
↓ ?
µ
[`It2] *Output 2 Integral
↓ ?
µ
[`rA2] *Output 2 Rate
↓ ?
µ
[`dE2] *Output 2 Derivative
↓ ?
µ
[`Ct2] *Output 2 Cycle Time
↑
↓ ?
←
µ
[``db] *Dead Band (page 5.17)
Enter your settings,
from the controller’s
upper display.
Comments to this Manuals