Watlow CLS200, MLS300 and CAS200 User Manual download pdf (Page 77)

Chapter 3: Controller Parameter Descriptions

Communications Speciﬁcation 71

• Default: 1000 (10.00 volts) or 2000 (20.00 mA).

Save Setup to Job (73)

This parameter saves the current setup to one of eight jobs. It is used as

a command; it is not used as data. When this parameter is set to a non–

zero value, the current job is saved to that job number. The parameter is

then immediately reset to zero. The job is only saved once, when the

controller receives this command. To resave the job, resend the

command.

• Range: 1 to 8.

• Default: 0 (no job).

Input Filter (74)

The adjustable input ﬁlter dampens the analog input response.

• Range: 0 to 255 scans. (Setting the number of scans to 0 disables the

ﬁlter.)

• Default: 16CLS and 8CLS = 3 Scans (both are equal to 1 second),

4CLS measurement = 6 Ambient = 0.

Loop Alarm Delay (75)

Delays process and failed sensor alarms for a loop until the alarm

condition has been continuously present for longer than the speciﬁed

alarm delay time.

• Range: 0 to 255.

• Default: 0 seconds (no loop alarm delay).

NOTE

MLS EPROMS prior to Version 2.30 do not support the

loop alarm delay.

Loop Names (77)

This parameter assigns a two-character name to each loop for CLS,

CLS2001, MLS and MLS300 controllers. For CAS and CLS200 see

Channel Name (78).

• Range: 0 to 9, A to Z, °, /, %.

• Default: The loop’s number.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 91 92

No comments

Watlow CLS200, MLS300 and CAS200 User Manual Page 77